Electronics Engineering Herald                  ADVT
Home | News | New Products | India Specific | Design Guide | Sourcing database | Student Section | About us | Contact us | What's New
Processor / MCU / DSP
Memory
Analog
Logic and Interface
PLD / FPGA
Power-supply and Industrial ICs
Automotive ICs
Cellphone ICs
Consumer ICs
Computer ICs
Communication ICs (Data & Analog)
RF / Microwave
Subsystems / Boards
Reference Design
Software / Development kits
Test and Measurement
Discrete
Opto
Passives
Interconnect
Sensors
Batteries
Others

New Products

  Date: 27/03/2013

Demonstration circuit by ADI for a loop powered HART

Analog Devices has introduced the CN0267 demonstration circuit for a loop powered HART (Highway Addressable Remote Transducer) enabled smart transmitter, for industrial applications that need to operate within a set 3.5-mA power budget. This field instrument circuit is tested and verified by ADI.

This circuit has been compliance tested, verified and registered as an approved HART solution by the HART Communication Foundation. The 7-cm by 2.3-cm CN0267 PCB demonstrates a direct sensor interface, microprocessor and two-way HART communication over a 4- 20-mA loop.

CN0267 combines three of ADI’s lowest power, high performance components, optimized for field instrument designs;

The ADuCM360, a low power, fully integrated, 3.9-kSPS, 24-bit data acquisition system-on-a-chip incorporating dual, sigma-delta A/D converters, a 32-bit ARM CortexTM M3 MCU, and flash/EE memory.
The AD5421, is a complete, loop powered, 16-bit, 4-mA to 20-mA DAC that incorporates a programmable voltage regulator used to power the demonstration board.
The AD5700 is a complete HART modem IC, consuming 38 percent less power and supporting a greater than 75 percent saving in board area over alternative products.

To learn more visit analog.com



 
ADVT
Home | News | New Products | India Specific | Design Guide | Sourcing database | Student Section | About us | Contact us | What's New
©2010 Electronics Engineering Herald